For best and most consistent results, Coliseum DTF Transfers should be applied with a heat press. A household iron can work for personal projects but may reduce durability.
General Guidelines
- Heat Setting: Cotton / Linen (high, no steam)
- Press Time: 15–20 seconds per section
- Pressure: Very firm, using body weight
Step-by-Step
- Prep surface & garment
Use a hard, heat-safe surface (countertop or table). Avoid ironing boards.
Place a folded towel or pressing mat under the garment.
Pre-iron the area for 5–10 seconds to remove moisture and wrinkles. - Position the transfer
Place the transfer design-side down on the garment.
Cover completely with parchment or baking paper. - Apply heat in sections
Press the iron straight down on one section at a time for 15–20 seconds.
Use firm pressure—do not slide the iron.
Lift and move to the next section until the entire design has been covered, slightly overlapping each area. - Peel the film
Let the transfer cool for a few seconds to a warm temperature.
Carefully peel the film in a slow, steady motion.
If part of the design lifts, cover again and re-press that area for a few more seconds. - Finishing press
Place parchment over the finished print.
Press each section again for 5–8 seconds with firm pressure.