Cricut

General Settings

• Temperature: 305–315°F (152–157°C)
  
• Pressure: Firm, using body weight
  
• First Press Time: 10–15 seconds
  
• Second Press Time: 5–8 seconds
  

Step-by-Step

1. Prep your pressing surface
   
   
   Use a firm, heat-safe surface (not a soft ironing board).
   
   
   Place a pressing mat or folded towel underneath the garment.
   
   
   
2. Prep the garment
   
   
   Pre-press area for 5–10 seconds to remove moisture and wrinkles.
   
   
   
3. Position the transfer
   
   
   Lay the DTF transfer on the garment, design facing the fabric, film on top.
   
   
   Make sure it’s flat with no bubbles.
   
   
   
4. First press
   
   
   Set Cricut press to 305–315°F for 10–15 seconds.
   
   
   Place the press directly over the design and apply firm, even pressure with both hands.
   
   
   Do not move the press around—keep it still.
   
   
   
5. Peel the film
   
   
   Allow to cool for a few seconds to warm peel, then peel in a smooth, steady motion.
   
   
   If edges lift, lay film back down and press for an additional 5–7 seconds.
   
   
   
6. Second press
   
   
   Cover print with parchment or a Teflon sheet.
   
   
   Press again for 5–8 seconds with firm pressure to finish.